Folding ice hut build, Work in progress

[Garvdarb]

I'd say it will hold if you don't move it. Lol what about rivets and dab the wee holes with calling.

[jignhookz]

I went with a tube of gorilla glue. It seems to hold up okay but I put in a few screws where the tin was wavy. I put on the hinges to connect the roof to the wall. Small progress but it still feels good. I have no ice to put it on anyway.

Still lots of work to do thanks for the replies and positive comments.

[Garvdarb]

Pop rivet in between and caulk as well.

[jignhookz]

Added a tad more tin and finished the plywood side . It folds down nicely on plywood side. I have not folded the other walls and roof yet. Starting to look like something.

[jignhookz]

I'm getting into high gear with the hut. I got the last of the tin on the hut and got some more 3/8 ply installed. I did a little staining with deck stain I didn't get too far.

[jignhookz]

Tin and ply on other side.

[jignhookz]

A little more staining I have build and stained the last wall for the door side. I need to install it and put little trim pieces in. I'm almost done! I'll post more pics soon.

[jignhookz]

Door side and top panel to be installed.

[jignhookz]

Panel.

[jignhookz]

So close to being finished. Just a bit of insulation to put in and some hardware.

[Garvdarb]

I'm looking forward to seeing it folded and possibly a step by step pics of opening it up. If you could.
Interesting

[jignhookz]

Folding down

[jignhookz]

Folding

[jignhookz]

Folding

[jignhookz]

Folding